A simple guide to heat curing

Curing your screen printed garment

When you have printed the garment you need to cure the ink otherwise when the garment goes through the wash you will notice that it fades, cracks and in some circumstances disappears altogether. There are some inks that are air dry but popular inks such as plastisol and waterbased inks need to be cured.

Curing is the actual chemical process by which the ink dries and bonds to the shirt fabric.

We are often asked ‘what is the best equipment to cure screen printing textile ink?’ The simple answer is a tunnel dryer however they can be expensive especially when starting off, so what are the options?

Important: Not all textile ink cure at the same time or temperature. Have a look at ‘The Cure’ which looks into ink curing in some detail.

Always check the documentation that comes with your ink and remember that the best test is always a wash test.

What equipment can be used?

Hair dryer

Hair Dryers – they are not hot enough, they will dry a waterbased ink but not cure it – NOT RECOMMENDED

 

 

IronIron – Don’t give an even heat and most are not hot enough to cure the ink fully. If you are printing T Shirts for your own use and are not worried about the ink gradually disappearing then an iron is an option – NOT RECOMMENDED

Heat GunHeat Guns – With a lot of patience and skill you could cure the ink but you are likely to scorch the garment so be careful. You can use a heat gun to touch dry the ink (the same job as a flash dryer) prior to printing the next colour – NOT RECOMMENDED (limited use)

 

Flash dryersFlash Dryers – normally used for touch drying the ink between prints when printing multi colour, it is possible to use a flash dryer to cure the ink but can be time consuming and requires management to ensure the garment does not burn. Works better for plastisol ink than waterbased ink (which requires longer cure).   LIMITED USE FOR LOW PRODUCTION.

 

 

 

Hand CurerHand Curer – can be used for both touch drying the ink between prints when printing multi colour and comes with a timer making use easier. Can also be used for ink curing as the hand curer uses quartz elements which heat immediately and cool immediately making the equipment safer and more energy efficient than a traditional flash dryer. We use hand curers for exhibitions and training sessions. RECOMMENDED FOR LOW PRODUCTION.

Heat PressHeat Presses – are fine for curing low numbers of garments, most modern presses have timers making it easier to manage. Heat Presses are used for lots of different applications such as vinyl transfer so commonly found in most T Shirt printing shops.

When using a heat press to cure screen printing inks you will need to put some grease proof paper or transfer release paper on the ink first before curing. You will need only a very light pressure and you will need to set the timer according to the ink you are using. Can be used for curing screen printing textile inks

 

Tunnel DryerTunnel Dryers – the best solution to cure large numbers of garments in a short space of time but the most expensive. They can cure potentially hundreds of garments per hour. We make them to all shapes and sizes based on the level of production and the size of garments being used.   If you are printing with waterbased inks choose the longest dryer you can afford to avoid having to put the garment through twice. HIGHLY RECOMMENDED